Overview - Fender, RS3

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Fender, Rs3

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 2 Nm
Bolt
- 4.5 Nm
- Quantity: 2
Mount
- For the bumper cover
- To secure the headlamp
- Removing and installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, RS3 .
Bolt
- Tightening specification. Refer to HEADLAMPS .
Mount
- For the headlamp
Bracket
- For the fender
- Removing and installing. Refer to FENDER BRACE, REMOVING AND INSTALLING
Bolt
- 8 Nm
- Quantity: 2
Fender
- Removing and installing. Refer to FENDER, REMOVING AND INSTALLING
- Overview - bracket on right fender. Refer to OVERVIEW - BRACKET ON RIGHT FENDER
- Repair kit. Refer to OVERVIEW - FENDER REPAIR KIT .
Seal
- Self-adhesive
- Only on the right side of vehicle
Bolt
- 8 Nm
- Quantity: 3
Bolt
- 8 Nm
Expanding Rivet
- Quantity: 2
Grommet
- Quantity: 3
Bolt
- 8 Nm
Bolt
- 8 Nm
- Quantity: 2
Cover
- For the wheel housing liner
- Removing and installing. Refer to WHEEL HOUSING LINER COVER, REMOVING AND INSTALLING
End Panel
- Removing and installing. Refer to END PLATE, REMOVING AND INSTALLING
Double Bolt
- 8 Nm
Insulation
- For the fender
Bolt
- 8 Nm
- Quantity: 2