Lifter, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Clean the adjusting screw threads -3- with a wire brush.
-- Clean the threaded hole of the lifter -1- of locking compound residue with a thread tap.
-- Check the stop washer -2- for damage.
- The stop washer must sit in the groove -arrow-.
-- Insert the adjusting bolt -3- with locking fluid in the lifter -1-, place in the roof cut out and secure.
-- Install the roof railing. Refer to ROOF RAILING, REMOVING AND INSTALLING .