Wheel Housing Liner Cover, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Clean the adhesive surface on the fender using Cleaning Solution :D 009 401 04  .

-- Remove the protective film from the adhesive tape -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Place the cover -2- on the front of the fender by pressing the securing pins -arrows- into the mount.

-- Press the cover on the entire length of the fender -3-.

• Resting time approximately 30 minutes at room temperature