Overview - Steering Column Switch Module With Mechanical Ignition Switch

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Steering Column Switch Module (with Mechanical Ignition Switch)

Courtesy of AUDI OF AMERICA, LLC

Steering Column
Bolt
- For steering lock housing (shear bolt)
- Quantity: 2
Lock Cylinder
- Removing and installing. Refer to LOCK CYLINDER, REMOVING AND INSTALLING .
Ignition Key
Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138-
  CAUTION:
  Risk of damaging coil connector.
  - Coil connector with slip ring is not to be turned following removal.
- Removing and installing. Refer to STEERING COLUMN ELECTRONICS CONTROL MODULE -J527-, REMOVING AND INSTALLING .
Transport Protection
Bolt
- 1.1 Nm
Mount
- With Turn Signal Switch -E2-, Windshield Wiper Intermittent Mode Switch -E22-
- Vehicle equipment version with cruise control system: with Cruise Control Switch -E45-
- Removing and installing. Refer to STEERING COLUMN COMBINATION SWITCH, REMOVING AND INSTALLING .
Steering Lock Housing
- Removing and installing. Refer to STEERING LOCK HOUSING, REMOVING AND INSTALLING .
Bolt
- 1.1 Nm
Ignition/Starter Switch -D-
- Removing and installing. Refer to IGNITION/STARTER SWITCH, REMOVING AND INSTALLING .
Ignition Switch Key Lock Solenoid -N376-
- Vehicle equipment version with DSG^® transmission
- Removing and installing. Refer to IGNITION SWITCH KEY LOCK SOLENOID -N376-, REMOVING AND INSTALLING .