Lock Cylinder, Removing And Installing: Installing

Install in the reverse order of removal. Note The Following: 

-- Insert the ignition key into the lock cylinder -1- and turn it to the ignition "on" position.

-- Push in the welding wire further in the front side opening until it stops, while doing so push the safety lever -3- until stop to the lock cylinder.

Courtesy of AUDI OF AMERICA, LLC

• The welding wire must poke out of the opening -arrow- in the safety lever.

-- Connect the connector -2- to the anti-theft immobilizer reader coil.

-- Insert the lock cylinder -1- with the reader coil into the steering lock housing.

-- Remove the welding wire and push the lock cylinder in securely, until the safety lever engages audibly.