Matrix Led Headlamp, Calibrating Using Headlamp Adjusting Unit: Vas5209B: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Headlamp Adjusting Unit :VAS5209B
-- The Matrix LED headlamp is calibrated using the Vehicle Diagnostic Tester.
-- In this procedure the low beam is set first. Then the Matrix beam high beam function is calibrated.
TIP
Software version from V 0.80 for the Headlamp Adjusting Unit :VAS5209B is required to calibrate the Matrix beam high beam function.
The Matrix Headlamp must be Calibrated after the Following Work:
- Headlamp position was changed (removing and installing, loosening and tightening the screws)
- Headlamps were adjusted.
- The Drivetrain Control Module -J775- was calibrated or replaced.
- The Left Rear Level Control System Sensor -G76-, Right Rear Level Control System Sensor -G77-, Left Front Level Control System Sensor -G78- or Right Front Level Control System Sensor -G289- was replaced.
- "No or incorrect basic setting/adaptation" is stored in the DTC memory.
- Left LED Headlamp Power Output Module 1 -A31- /Right LED Headlamp Power Output Module 1 -A27- was replaced.
Requirements
- Pay attention to the testing and adjustment requirements. Refer to HEADLAMP, ADJUSTING .