Wheel Housing Extension, Removing And Installing: Installing

Install In Reverse Order Of Removal and Note The Following: 

Sedan:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Clean the adhesive surface using the Cleaning Solution :D 009 401 04  .

-- Remove the protective film from the adhesive tape -3 and 4-.

Courtesy of AUDI OF AMERICA, LLC

-- Position the wheel housing extension -1- and tighten the bolt -2-.

-- Press on the entire length of the wheel housing extension.

• Resting time approximately 30 minutes at room temperature

Installing 

Install In Reverse Order Of Removal.