Molded Foam Part, Removing And Installing, A3: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal and Note The Following:
Vehicles through MY 2016:
-- Position the pressure hose -2- at the center of the color mark -3- in the recess on the specified marking -4- in the molded foam part -1-.
-- Position the pressure hose evenly in both directions -arrows- in the recess in the molded foam part.
WARNING:
Risk of damaging the pressure hose by deforming it
- Never kink or stretch the pressure hose.
-- Fasten the molded foam piece -1- at the left and right with a cable tie -2- on the bracket, the cable tie head -arrow- must sit at the bottom the molded foam piece.