Sun Visor, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Unclip the sun visor mount expanding cap -1- -arrow- by sliding the :VAS6416 just approximately 1 mm under the cap.
NOTE:
If the :VAS6416 is inserted farther, it will be located under the sun visor. It is then not possible to pry out the expanding cap.
-- Disengage the sun visor -2- at the center support.
-- Unclip the sun visor mount -1- with the clamp -2- downward -arrow- from the opening in the body and remove it.
-- Equipped on some models: disconnect the connector and remove the sun visor.