Lane Change Assistance, Calibrating, Vehicles Through My 2016: Procedure
-- Turn on the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- at the power switch -3-.
- The green LED -1- must turn on.
If the red LED -2- comes on: Check the :VAS6350/4 .
-- Follow the instructions in the vehicle diagnostic tester display.
During the program sequence, a request is made to switch the :VAS6350/4 from the right to the left side of the :VAS6350A .
-- Turn off the :VAS6350/4 and reposition the calibration tool.
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).
Different adjustment dimensions apply for the Lane Change Assistance Control Module 2 -J770- with the part number :5Q0 907 568 .
Dimension -a- is measured from the upper edge of the calibration device to the floor.
| Model | A3 Compact (3-doors) | A3 Sportback | A3 Sedan | A3 Cabriolet |
|---|---|---|---|---|
| All versions | All versions | All versions | All versions | |
| Adjustment dimension height in mm dimension -a- | 865 | 847 | 847 | 848 |
| Adjustment dimension height in mm dimension -a- for the Lane Change Assistance Control Module 2 -J770- with the part number :5Q0 907 568 | 889 | 874 | - | - |
- The indicator on the base of the :VAS6350/4 must align with adjustment dimension on the measuring scale -1- on measuring field -arrow-.
Different adjustment dimensions apply for the Lane Change Assistance Control Module 2 -J770- with the part number :5Q0 907 568 .
| Model | A3 Compact (3-doors) | A3 Sportback | A3 Sedan | A3 Cabriolet | ||
|---|---|---|---|---|---|---|
| All versions | Base | S-line, S3 | RS3 | All versions | All versions | |
| Right adjustment dimension in mm | 777 | 666 | 756 | 848 | 757 | 590 |
| Left adjustment dimension for the Lane Change Assistance Control Module 2 -J770- with the part number :5Q0 907 568 | 656 | 666 | - | - | ||
-- Turn on the :VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
-- Follow the instructions in the vehicle diagnostic tester display.
-- After calibrating the lane change assistance successfully, end "calibration", switch off the ignition and disconnect the diagnostic connector.