Lane Change Assistance, Calibrating, Vehicles From My 2017: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Turn on the :VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
NOTE:
If the red LED -2- comes on: Check the :VAS6350/4 .
-- Follow the instructions in the vehicle diagnostic tester display.
During the program sequence, there is a prompt to switch the :VAS6350/4 from the left to the right side of the :VAS6350A .
-- Turn off the :VAS6350/4 -VAS6350/4- and reposition the calibration tool.
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).
| Model | A3 Compact (3-doors) | A3 Sportback | A3 Sedan | A3 Cabriolet | A3 e-tron |
|---|---|---|---|---|---|
| Adjustment dimension height in mm dimension -a- | 838 | 810 | 727 | 736 | 833 |
- The indicator on the base of the :VAS6350/4 must align with adjustment dimension on the measuring scale -1- on measuring field -arrow-.
| Model | A3 Compact (3-doors) | A3 Sportback | A3 Sedan | A3 Cabriolet | A3 e-tron |
|---|---|---|---|---|---|
| Right adjustment dimension in mm | 639 | 654 | 641 | 641 | 654 |
-- Turn on the :VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
-- Follow the instructions in the vehicle diagnostic tester display.
-- After calibrating the lane change assistance successfully, end "calibration", switch off the ignition and disconnect the diagnostic connector.