Starter, Removing And Installing, Vehicles With 1.0L, 1.2L, 1.4L And 1.8L TFSI Engine And Manual Transmission: Removing
-- With the ignition switched off, disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING, ENGINE COMPARTMENT BATTERY .
-- If present, detach the transmission ventilation -1- from the battery tray and set aside by releasing the catch -2- and removing the transmission ventilation upward in the direction of -arrow-.
-- Turn the transmission ventilation to the side near the starter.
-- Disconnect the connector -1- by sliding the retainer back and pressing the release down.
-- Remove the cap -2-.
-- Remove the terminal 30/B+ wire -3- from the starter.
-- Remove the noise insulation. Refer to NOISE INSULATION .
-- Remove the nut -4- and remove the bracket -1- for the wires. The wires remain connected.
-- Remove the bolts -2 and 5- and then remove the starter -3- upward.