Battery, Removing And Installing, Battery In Luggage Compartment: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Connect the Vehicle Diagnostic Tester.
-- Select the Diagnostic mode and start the diagnostics.
-- Select the test plan tab.
-- Select the Select individual tests button and choose the following sequence.
- Body
- Electrical Equipment
- 01 - OBD-capable systems
- 19 - Data Bus On Board Diagnostic Interface - J533
- 19 - Data Bus On Board Diagnostic Interface functions
- 19 - Adapting
- 19 - Adapt battery
When the battery is connected, the following steps must be performed:
- Activate the one-touch up/one-touch down power window regulators. Refer to the Owner's Manual.
- Check all the DTC memories and erase the "undervoltage" entry using the Vehicle Diagnostic Tester.
NOTE:
After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.