Battery In Engine Compartment, Removing And Installing: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Connect the :Vehicle Diagnostic Tester .
-- Choose operation mode Diagnosis and start the diagnosis.
-- Select the tab test plan .
-- Select select individual tests and choose the following sequence.
- Body
- Electrical Equipment
- 01 - OBD-capable systems
- 19 - Data Bus On Board Diagnostic Interface - J533
- 19 - Data Bus On Board Diagnostic Interface functions
- 19 - Adapting
- 19 - Adapt battery
When the battery is connected, the following steps must be performed
- Activate the one-touch up/one-touch down power window regulators. Refer to the Owner's Manual.
- Check DTC memories of all control modules and erase "Undervoltage" DTC if necessary, using the :Vehicle Diagnostic Tester .
NOTE:
After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.