Threshold A In Mm
WARNING: This page is about a different variant/trim than selected.
NOTE:
If the readout value is greater than the limit value "a" (table value): insufficient damping effect → replace shock absorber.
If the readout value is less than the limit value "a" (table value): sufficient damping effect → shock absorber does not need to be replaced.
| Vehicle Type | Front Axle | Rear Axle | Comment |
|---|---|---|---|
| Standard suspension 2UA | 43 mm | 52 mm | No load tank full |
| Heavy duty suspension 2UA | 43 mm | 52 mm | No load tank full |
| Sport chassis (2UC) | 42 mm | 50 mm | No load tank full |
| S-line Sport suspension 2UG | 42 mm | 50 mm | No load tank full |
The Tires Must Be "Partially Loaded" When Measuring the Tire Pressure.