Shock Absorbers, Checking On Shock Tester
Special tools and workshop equipment required
- Maha Shock Absorber Tester:VAS1990
- Axle Damping Tester:VAS6636
- Axle Damping Tester:VAS6640
Shock absorbers can be checked while installed using the shock tester (shock absorber testing device). The damping effect can be evaluated based on the dial reading or print-out.
Test Prerequisites:
- Temperature 10° 40° C (50° - 104° F)
- Driver in vehicle.
- Tire pressure OK
- Drive vehicle straight onto center of wheel contact plates.
- Front wheels in straight position.
- Parking not engaged, foot brake not activated.
Threshold:
Shock absorber condition can only be judged as follows:
- Sufficient damping effect
or
- Insufficient damping effect
Intermediate values for reduced damping performance cannot be read out.
A prognosis on service life is not permitted.
Measured values that occur with the involvement of the suspension travel end stops are incorrect.
The following values apply only to the test stands named above. If the specified values are exceeded, the shock absorber action has weakened enough that a replacement is recommended.
b
Threshold = 70
- -a- = greater than 70: insufficient damping effect
- -a- = less than 70: sufficient damping effect
The shock absorber combination installed in the vehicle is indicated by the corresponding PR number on the vehicle data plate.
Production Control Number (PR number) explanation. Refer to EXPLANATIONS OF PRODUCTION CONTROL NUMBERS (PR NUMBER) .