Transmission Control Component Location Overview
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Lamp Switch -F- /Brake Pedal Switch -F63-
- On the main brake cylinder
- Assembly overview. Refer to COMPONENT LOCATION OVERVIEW - ABS/ESP .
- DSG Transmission Mechatronic -J743-
- Fastened to the front of the transmission housing.
- Removing and installing. Refer to Direct Transmission Mechatronic -J743-, REMOVING AND INSTALLING
- Selector Lever -E313-
- With Selector Lever Sensor System Control Module -J587-, Shift Lock Solenoid -N110- and Selector Lever Park Position Lock Switch -F319-.
- The components are integrated in the circuit board for the shift mechanism function unit and cannot be replaced individually.
- Gearshift mechanism, removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING
- Selector Lever Transmission Range Position Display Unit -Y26-
- Removing and installing. Refer to Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING
- Transmission Range Display -Y6-
- Integrated in the instrument cluster
- Cannot be replaced individually
- Instrument cluster assembly overview. Refer to OVERVIEW - INSTRUMENT CLUSTER .
- Kick Down Switch
- A programmed value from the Accelerator Pedal Position Sensor -G79- and Accelerator Pedal Position Sensor 2 -G185- (integrated in accelerator pedal module) are saved in the Engine Control Module (ECM) as a kick-down signal.
- Signal transmitted from ECM to Transmission Control Module (TCM) via CAN Bus
- Accelerator pedal module assembly overview. Refer to OVERVIEW - ACCELERATOR PEDAL MODULE .
- Data Link Connector (DLC)
- For the Vehicle Diagnostic Tester
- In driver-side footwell
- Check all the listed components Vehicle Diagnostic Tester, Guided Fault Finding