Right Seal, Replacing, Vehicles With Front Wheel Drive

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller - Crankshaft/Power Steering Seal: T20143
Seal Installer - Flange Shaft: 3377
Grease. Refer to the Parts Information.

Procedure

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the seal using the : T20143/2

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the Parts Information.

Fig 1: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Install the seal all the way in using the : 3377 . Be careful not to tilt it.

Fig 2: Driving New Seal In As Far As Stop

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .