Right Flange Shaft, Removing And Installing, Vehicles With All Wheel Drive: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Vehicles with a TFSI engine: Remove the nuts -arrows- and remove the right drive axle heat shield.

Fig 1: Identifying Right Drive Axle Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Place the : SMN372500 under the transmission.

Fig 2: Identifying Right Flange Shaft Countersunk Bolt, Socket And Key T10107

Courtesy of AUDI OF AMERICA, LLC

-- Remove right flange shaft bolt with : T10107A by installing two screws in flange and counter holding flange shaft with assembly lever.

-- Attach the : T10037 as shown in the illustration, to the right flange shaft.

Fig 3: Identifying Puller T10037 And Right Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Align : T10037 with : T10037/1 and the spindle -A- parallel to the flange.

-- Remove flange shaft.