Right Seal, Replacing, AWD Vehicles
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit :SMN372500
- Seal Installer - Bevel Box :T10243
- Puller - Crankshaft/Power Steering Seal :T20143
- Puller - Crankshaft/Power Steering Seal :T20143/1
- Puller - Crankshaft/Power Steering Seal :T20143/2
- Sealing Grease Refer to the Parts information.
- Pay attention to the general information. Refer to GENERAL INFORMATION .
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Pay attention to the general repair information. Refer to GENERAL REPAIR INFORMATION .
-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .
-- Place the :SMN372500 underneath.
-- Pry out the seal on the transmission using the :T20143/1 or :T20143/2 .
-- Coat the outer edge and sealing lips on the new seal with transmission fluid.
-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts information for the correct Sealing Grease.
-- Drive the new seal all the way in using the :T10243 . Do not tilt the seal while doing so.
-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .
-- Check the transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .