Seal On Bevel Box Between Transmission And Bevel Box, Replacing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Bevel Box :T10298
Puller - Crankshaft/Power Steering Seal :T20143
Sealing Grease. Refer to the Parts information.

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .

-- Pry out the seal on the bevel box using the :T20143/1 or :T20143/2 .

-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts information for the correct sealing grease.

-- Drive the new seal all the way in using the :T10298 . Do not tilt it while doing so.

-- Install the bevel box. Refer to BEVEL BOX, REMOVING .