Vacuum Pump, Removing And Installing, 5-Cylinder TFSI Engine: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
NOTE:
Replace the seal.
-- Make sure the seal is in the correct installation position.
-- Turn the vacuum pump yoke -1- so that it engages in the grooves on the drive chain sprocket for the camshaft timing chain when positioning the vacuum pump -arrows-.