Vacuum Pump, Removing And Installing, 4-Cylinder TFSI Engines: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
NOTE:
Replace the seal.
-- Make sure the seal is in the correct installation position.
-- Turn the vacuum pump yoke -1- so it engages in the groove on the camshaft when positioning the vacuum pump -arrows-.