BLEEDING WITH ABS Hydraulic Unit -N55- PUMP

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

If the brake system cannot be bled correctly, proceed as follows:

NOTE:

The hydraulic pump must be activated by the interchange test.

-- Bleed the hydraulic system. Refer to HYDRAULIC SYSTEM, BLEEDING .

Also:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start OBD mode.

-- Select 003- Brake electronics .

-- Select the basic setting button.

-- Bleed the brakes.

-- Use login 40168.