Fuel Level Sensor 2 -G169-, CHECKING: Notes

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Analog/Digital Multimeter :FLU83III
Connector Test Set:VAG1594D
Trim Removal Wedge:3409

NOTE:

For North American market versions, there is no sealing flange on the left side of the fuel tank. Therefore the Fuel Level Sensor 2 -G169- can only be checked when installed. Refer to Fuel Level Sensor 2 -G169-, CHECKING => Fuel Level Sensor 2 -G169- is Installed: .

Procedure

-- Move the front seats all the way forward.

-- Switch off the ignition.

-- Remove the rear bench seat. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Unclip the right sealing flange cover -1- at the tabs in direction of -arrows- using the :3409 .

Fig 1: Fuel Pump Cover (Under Rear/Bench Seats)

Courtesy of AUDI OF AMERICA, LLC

Version 1:

Courtesy of AUDI OF AMERICA, LLC

-- Unlock the connector safety catch and disconnect the connector -2- on the right sealing flange.

NOTE:

Ignore -1-.

Version 2:

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch to disconnect the connector -1- on the right sealing flange.

NOTE:

Ignore -2-.