LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Fuel Supply System [CNSA,CNTA,CNSB,CYFB,CZRA]) >> 20 Fuel Supply System >> Accelerator Mechanism >> Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing >> Installing

Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and Note The Following  :

CAUTION:

There is a risk of damaging the surface of the knee airbag from mechanical stress.

  • After completing a procedure, perform a visual inspection to make sure that the surface of the knee airbag is not damaged.

-- Install the steering column cover. Refer to UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING / LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

NOTE:

Depending on the engine/transmission combination, an adaptation must be performed after replacing.

If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.