Engine Coolant Temperature Sensor On Radiator Outlet -G83-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is cold.
-- Briefly open the coolant expansion tank cap -arrow- and release any residual pressure in the cooling system and then close it again until it locks.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION / NOISE INSULATION, REMOVING AND INSTALLING .
-- Disconnect the connector -1-.
-- Remove the clamp -2- and Engine Coolant Temperature Sensor on Radiator Outlet -G83- -3-.
NOTE:
Place a cloth underneath to catch any leaking coolant.
Insert the new Engine Coolant Temperature Sensor on Radiator Outlet -G83- immediately in the connection to prevent coolant loss.