Coolant Pump Toothed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Note the toothed belt sprocket installation location, refer to -item 12- (OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT, ENGINE WITH Engine Temperature Control Actuator -N493-).
Replace the bolts that were tightened with an additional turn after removing them.

-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP/COOLANT THERMOSTAT .