Closing Locks, Checking, Vehicles With Keyless Stop And Start System

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Press the Access/Start Authorization Button -E408- briefly to get "ignition on".

-- Do not move the selector lever into "P" but rather, for example, into "N".

-- Turn off the ignition.

A warning message must appear in the instrument cluster.
The vehicle cannot be locked.

-- Switch on the ignition and shift the selector lever into the "P" position.

-- Turn off the ignition.

The vehicle can be locked.

If the specified values are not obtained:

-- Use the Vehicle Diagnostic Tester in Guided Fault Finding for fault finding.

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the locking button on the selector lever handle. Refer to 4. Selector Lever Handle Locking Button, Checking below.