Selector Lever Handle, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The locking button -2- points in the direction of travel.
CAUTION:
- Do not press the locking button on the selector lever handle.
-- Press the selector lever handle -1- completely onto the selector lever -arrow B- without touching the locking button -2-.
- The selector lever handle must engage into the ring groove of the selector lever.
-- Turn the locking ring all the way in the direction of -arrow B-.
- It must be possible to turn the locking ring. If necessary, press the selector lever handle again.
- The tab -1- on the locking ring is under the tab -2- on the selector lever handle.
- The selector lever handle is only properly locked if the locking ring was turned. Only then may the locking button on the handle be pressed.
- The locking button may have an increased resistance to pressure the first time it is pushed after installing the selector lever handle.
-- Press the locking button on the selector lever handle.
-- Fold the selector lever boot downward and clip it in.
-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .