LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Controls, Housing (0D9) (2 Of 2) -- (A3)) >> 34 Controls, Housing >> Selector Mechanism >> Overview - Selector Mechanism

Overview - Selector Mechanism

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Selector Mechanism Exploded View
GWWA34-11156Courtesy of AUDI OF AMERICA, LLC
  1. Selector Lever Cable
    • Cannot be replaced separately
    • Do not lubricate
  2. Nut
    • 8 Nm
    • For selector mechanism to body
    • Quantity: 4
  3. Bolt
    • 4 Nm
    • For the selector mechanism to the selector housing
    • Quantity: 4
  4. Selector Mechanism
    • The following components are combined into a single component
      • Selector Lever -E313-
      • Selector Lever Sensor System Control Module -J587-
      • Selector Lever Park Position Lock Switch -F319-
      • Shift Lock Solenoid -N110-
      • Selector lever cable
    • The components cannot be replaced separately
    • To check the components, use the Vehicle Diagnostic Tester in Guided Fault Finding 
    • Selector mechanism emergency release. Refer to EMERGENCY RELEASE FROM P .
    • Selector mechanism, removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
  5. Selector Housing
  6. Base Plate
    • Always replace after removing
  7. Clips
    • Always replace after removing
  8. Bolt
    • 13 Nm
    • Selector lever cable adjusting bolt
  9. Joint Piece
  10. Selector Lever
  11. Nut
    • 20 Nm
  12. Lock Washer
  13. Cable Bracket
    • For the selector lever cable
  14. Bolt
    • 15 Nm
scientia non olet · About LEMON Manuals