Transmission Fluid Pan, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Replace the transmission fluid pan gasket and bolts.
-- Replace the O-rings -arrows- on the connector for the Dual-Clutch Transmission Mechatronic -J743-.
-- Remove any oil or grease from the sealing surfaces.
-- Coat the O-rings on the connector for the Dual-Clutch Transmission Mechatronic -J743- with transmission fluid.
-- Install the transmission fluid pan -A- with the transmission fluid pan gasket and tighten. Refer to Figure.
-- Fill with transmission fluid (refer to TRANSMISSION FLUID, DRAINING AND FILLING ) and check the transmission fluid level (refer to TRANSMISSION FLUID LEVEL, CHECKING ).