Bevel Box, Tightening Specification

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Replace the bolts after removing them.

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specification/Additional Turn
1.	-arrows-	Install all the way by hand
2.	-arrows-	40 Nm diagonally
3.	-arrows-	90° additional turn, diagonally

Fig 1: Tightening Sequence for Bevel Box Bracket (Vehicles with TFSI Engine)

Courtesy of AUDI OF AMERICA, LLC

Step	Bolts	Tightening Specification
1.	-1-	Install all the way by hand
2.	-2-	40 Nm
3.	-1-	40 Nm

Fig 2: Tightening Sequence for Bevel Box Bracket (0CN Transmission Support)

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specification
1.	-1-	Install all the way by hand
2.	-2-	40 Nm
3.	-1-	40 Nm