Dual Clutch, Installing: Installing: Notes
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Use special caution when removing the dual clutch from the packaging.
- Do not remove or lift the clutch pack, not even a small amount. The clutch plates can rotate themselves.
- If the drive plate comes out of the outer clutch plate carrier teeth, the plates can slip. The dual clutch can then no longer be adjusted correctly.
- To ensure that the multiplate clutch plates do not slip, press the drive plate into the outer clutch plate carrier with both thumbs during all of the following steps.
-- Check on the bottom of the dual clutch if the four hub seals are seated correctly and engage them in one another if necessary.
- Installation position: the ends of the rings are offset to each other.