Clutch End Cover with Bushing (Assembly Aid):

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the clutch end cover with the bushing.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of Leaks on the Clutch End Cover.

Transmission Damage Due to Oil Loss.

- Do not touch the seal in the inner opening of the clutch end cover!

- Do not load the clutch end cover by hitting with a hammer.

-- Push the clutch end cover evenly into its seat.

-- If necessary, carefully pry the clutch end cover into its seat with a screwdriver -arrow- as shown until the shaft ring can be installed.

Courtesy of AUDI OF AMERICA, LLC

-- Install the clutch end cover shaft ring in the transmission housing by counterholding the shaft ring on the opposite side so that it stays in its groove.

-- Using a screwdriver, make sure the shaft ring is completely engaged.

-- Remove the bushing (assembly aid).

Courtesy of AUDI OF AMERICA, LLC

Continuation for Both Clutch End Covers:

-- Fill the transmission fluid for the dual clutch transmission after installing it. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Perform the basic setting using the Vehicle Diagnostic Tester in Guided Functions .