Transmission Control Component Location Overview
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Lamp Switch -F- /Brake Pedal Switch -F63-
- On the main brake cylinder
- Assembly overview. Refer to SENSORS .
- DSGTransmission Mechatronic -J743-
- Fastened to the front of the transmission housing.
- Removing and installing. Refer to Direct Transmission Mechatronic -J743-, REMOVING AND INSTALLING
- Selector Lever -E313-
- With Selector Lever Sensor System Control Module -J587-, Shift Lock Solenoid -N110- and Selector Lever Park Position Lock Switch -F319-.
- The components are integrated in the circuit board for the shift mechanism function unit and cannot be replaced individually.
- Gearshift mechanism, removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING
- Selector Lever Transmission Range Position Display Unit -Y26-
- Removing and installing. Refer to Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING
- Transmission Range Display -Y6-
- Integrated in the instrument cluster
- Cannot be replaced individually
- Instrument cluster assembly overview. Refer to INSTRUMENT CLUSTER .
- Kick Down Switch
- A programmed value from the Accelerator Pedal Position Sensor -G79- and Accelerator Pedal Position Sensor 2 -G185- (integrated in accelerator pedal module) are saved in the Engine Control Module (ECM) as a kick-down signal.
- Signal transmitted from ECM to Transmission Control Module (TCM) via CAN Bus
- Accelerator pedal module assembly overview. Refer to ACCELERATOR MECHANISM[For engine(s) CNTC,CZRA] .
- Data Link Connector (DLC)
- For the Vehicle Diagnostic Tester
- In driver-side footwell
- Check all the listed components Vehicle Diagnostic Tester, Guided Fault Finding