Fill Gear Oil

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

All precautionary measures and test conditions must be followed.

-- Route the :VAS6291A upward.

-- Install the :VAS6291/3 until stop.

-- Attach the charging device hose with the :VAS6291/3 .

NOTE:

The hose must not hang through.

-- Check if the valve -arrow- is closed.

-- Install the oil container -A- on the :VAS6291A .

-- Open the valve -arrow- and hold the oil container as illustrated.

When gear oil flows out the :VAS6291/3 , the gear oil level is OK.

-- Hold the oil container in such a way so that any excess oil flows back into the container.

-- When the oil stops flowing, disconnect the charging device by pushing the tab.

-- Remove the :VAS6291/3 .

-- Install the old bolts for the oil filler hole and loosely tighten.

-- Start the engine, engage a gear and let the transmission turn for approximately two minutes.

-- Switch off engine and remove oil filler plug.

-- Checking the oil level If applicable, fill the gear oil to the lower edge of the filler hole.

Specified value: axle oil level up to bottom edge of oil filler hole.

Assembling

Assembly is performed in the reverse order of disassembly, noting the following:

NOTE:

Replace the oil filler hole drain plug.