Fill Gear Oil: Notes
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- All precautionary measures and test conditions must be followed.
-- If installed remove the bolts -arrows-, and remove the right drive axle heat shield.
-- Route the :VAS6291A upward.
-- Install the :VAS6291/3 until stop.
-- Attach the charging device hose with the :VAS6291/3 .
NOTE:
The hose must not hang through.
-- Check if the valve -arrow- is closed.
-- Install the oil container -A- on the :VAS6291A .
-- Open the valve -arrow- and hold the oil container as illustrated.
-- Hold the oil container in such a way so that any excess oil flows back into the container.
-- When the oil stops flowing, disconnect the charging device by pushing the tab.
-- Remove the :VAS6291/3 .