Right Flange Shaft, Removing And Installing, Vehicles With Front Wheel Drive: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the noise insulation -1-. Refer to NOISE INSULATION .

-- If installed: Remove the bolts -arrows- and remove the right drive axle heat shield.

-- Turn steering as far as possible toward right.

NOTE:

The following work procedures are illustrated on the left side.

-- Remove the drive axle from on the right of the transmission -arrow-. Refer to .

-- Remove the nuts -arrows- on the right ball joint.

-- Remove the nut from the bracket for the Right Front Level Control Sensor -G289-.

-- Remove the right ball joint from the transverse link.

-- Fasten the right ball joint -2- on the transverse link -1- with the nut -arrow-, as shown in the illustration.

-- Tie up the right drive axle toward the rear.

NOTE:

Be careful not to damage the protective coating on the drive axle.

-- Install two bolts into the flange, counterhold the flange shaft with the pry lever and remove the bolt -arrow- from the right flange shaft.

-- Remove flange shaft.