Right Flange Shaft, Removing And Installing, Vehicles With All Wheel Drive: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Vehicles with a TFSI engine: Remove the nuts -arrows- and remove the right drive axle heat shield.

-- Remove the right drive axle. Refer to DRIVE AXLE .

-- Place the :SMN372500 under the transmission.

-- Remove right flange shaft bolt with :T10107A by installing two screws in flange and counter holding flange shaft with assembly lever.

-- Attach the :T10037 as shown in the illustration, to the right flange shaft.

-- Align :T10037 with :T10037/1 and the spindle -A- parallel to the flange.

-- Remove flange shaft.