Left Flange Shaft, Removing And Installing: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the drive axle from the left of the transmission -arrow-. Refer to DRIVE AXLE .

-- Mark the position of the nuts -arrows- for the left ball joint, and remove them.

-- If installed: Remove the nut -4- and bolt -1-, and set aside the Left Front Level Control System Sensor -G78- -3-.

-- Remove the left ball joint from the control arm.

NOTE:

Ignore -2-.

-- Remove the nut -1- for the coupling rod -3- from the left of the stabilizer bar -2-.

-- Move the left drive axle forward.

NOTE:

Pay attention that the drive axle surface protection is not damaged.

-- Move the left suspension strut to the outside and support it with the :2024A/1 as illustrated.

WARNING:

There is the risk of an accident due to loose support parts.

Secure the securing pin and ball joint with the plug connector -arrow- and nut -1-.

-- Remove left flange shaft bolt by installing 2 bolts in flange and counter holding flange shaft with assembly lever.

-- Remove the flange shaft and the pressure spring.