Right Seal, Replacing: Procedure

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING, VEHICLES WITH ALL WHEEL DRIVE .

-- Remove the right seal with the :T20143 .

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the parts information.

-- Install the seal all the way in using the :T10049 . Be careful not to tilt it.

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING, VEHICLES WITH ALL WHEEL DRIVE .

-- Check the gear oil level. Refer to GEAR OIL, CHECKING LEVEL .