Overview - PREGLOW System: Notes
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Camshaft Position Sensor -G40-
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-ring
- If damaged replace the Camshaft Position Sensor -G40-
- Glow Plug
- Glow Plug 1 -Q10-
- Glow Plug 2 -Q11-
- Glow Plug 3 -Q12-
- Glow Plug 4 -Q13-
- Depending on the depending on the exhaust gas standard the cylinder internal pressure sensor is integrated additionally in the glow plug.
- Cylinder 1 Combustion Chamber Pressure Sensor -G677-
- Cylinder 2 Combustion Chamber Pressure Sensor -G678-
- Cylinder 3 Combustion Chamber Pressure Sensor -G679-
- Cylinder 4 Combustion Chamber Pressure Sensor -G680-
- Glow plug versions and tightening specifications. Refer to GLOW PLUG VERSIONS AND TIGHTENING SPECIFICATIONS .
- Removing and installing. Refer to GLOW PLUG, REMOVING AND INSTALLING .
- Connector
- Sealing Flange, Transmission Side
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4.5 Nm