Engine Speed Sensor -G28-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the noise insulation -1-. Refer to NOISE INSULATION .
-- Disconnect the electrical connector -1- using the Elbow Assembly Tool:T10118 .
TIP
To release the connector without the :T10118 , push the connector against the engine speed sensor and simultaneously lift up on the release tab with a thin wire hook.
-- Remove the bolt -2- using the :T10370 and remove the -G28-.