Installing (Adjusting Valve Timing)

• The tensioning roller must be secured with the : T10265  and fasted to the right stop with the nut -1-.

  Courtesy of AUDI OF AMERICA, LLC

• The metal tab -arrow- on the tensioning roller must fit into the cast depression in the cylinder head.

  Courtesy of AUDI OF AMERICA, LLC

• Secure the camshaft hub with the :3359  .

  Courtesy of AUDI OF AMERICA, LLC

• Bolt loosely installed.
• It must still be easily possible to rotate the camshaft toothed belt gear and it must not tip.

• Loosen the carrier bolt -1- half a turn in the center position in the oblong hole -2-.

  Courtesy of AUDI OF AMERICA, LLC

• Secure crankshaft using the :T10490  .

  Courtesy of AUDI OF AMERICA, LLC

• Secure the hub on the high pressure pump with the :T10492  .

  Courtesy of AUDI OF AMERICA, LLC

• Nut loosely installed.
• It must still be easily possible to rotate the high pressure pump toothed belt gear and it must not tip.

-- Turn the camshaft toothed belt gear and the high pressure pump toothed belt gear all the way clockwise by the oblong holes.

Courtesy of AUDI OF AMERICA, LLC

-- Mount the toothed belt in the following sequence:

1. Crankshafts - toothed belt gear
2. Tensioning roller
3. Camshaft toothed belt gear
4. Toothed belt sprocket for the high pressure pump
5. Coolant pump toothed belt gear

-- Loosen the nut -1- on the tensioning roller and remove the :T10265  .

Courtesy of AUDI OF AMERICA, LLC

• Tensioning roller metal tab must fit into the cast recess of the cylinder head.

  Courtesy of AUDI OF AMERICA, LLC

• The crankshaft holder -1- must not come into contact with the oblong hole upper stop after tensioning the toothed belt.

  Courtesy of AUDI OF AMERICA, LLC

-- Check if the camshaft holder -1- is between the center oblong hole and the lower stop -2-. If necessary adjust the position of the camshaft sprocket one tooth clockwise and install the toothed belt again.

-- Carefully turn the tensioning roller eccentric pulley clockwise in direction of -arrow- with the :T10264  until the indicator is located centrally in the gap of the base plate -2-.

Courtesy of AUDI OF AMERICA, LLC

• The nut -1- must not turn with it.

-- Hold the tensioning roller in this position and tighten the nut.

-- Mount the :T10172A  with the :T10172/11  on the camshaft toothed belt sprocket as illustrated.

Courtesy of AUDI OF AMERICA, LLC

-- Press the counterhold tool counter-clockwise -arrow- and hold it at pre-load.

-- In this position, tighten the bolt -1- for the camshaft toothed belt sprocket and the nut -2- for the high pressure pump toothed belt sprocket to 20 Nm.

-- Check after tensioning that the toothed belt sprocket is not on the >>stop<< of the range of rotation.

-- Make sure that the high pressure pump toothed belt sprocket is not aligned with the locking pin. If necessary adjust the position of the camshaft sprocket one tooth clockwise and install the toothed belt again.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :3359  , :T10492  and the :T10490  and check the valve timing. Refer to TOOTHED BELT, REMOVING AND INSTALLING .