Checking The Installed Position Of The Sensor Wheel On The Crankshaft:

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the nut -B- up to the end of the threaded spindle.

-- Remove both bolts -2- from the cylinder block.

-- Remove the knurled bolts -H- from the sealing flange -1-.

-- Remove the hex socket head bolts -E- from the crankshaft flange and remove the :T50010 from the crankshaft flange.

-- Remove the sealing lip support ring.

-- Attach the :VAS6082 to the crankshaft flange -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Measure the distance -a- between the crankshaft flange -2- and the sensor wheel -1-.

Courtesy of AUDI OF AMERICA, LLC

Specified value: dimension -a- = 0.5 mm

-- Install the sensor wheel again if the measured value is too small. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH EIGHT CONNECTION AREAS .

-- When the specified value is reached, perform the rest of the assembly. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH EIGHT CONNECTION AREAS .

Pressing the Sensor Wheel on Again:

Courtesy of AUDI OF AMERICA, LLC

-- Secure the :T50010 on the crankshaft flange.

-- Pay attention that the :T50010 locating pin is seated in the sensor wheel hole.

-- Tighten both hex socket bolts -E- using the hex socket wrench -3- hand-tight.

-- Push the :T50010 by hand to the sealing flange -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the nut -B- as far as possible on the threaded spindle by hand until it touches the :T50010 .

-- Push the guide pin -C- in the crankshaft flange.

-- Install two M6 x 35 bolts -2- for guiding the sealing flange -1- into the cylinder block.

-- Tighten the :T50010 nut -B- to 40 Nm.

Courtesy of AUDI OF AMERICA, LLC

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH EIGHT CONNECTION AREAS .

-- Tighten the nut on the :T50010 to 45 Nm if the measured value is too small.

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH EIGHT CONNECTION AREAS .