Seals Component Location Overview
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Right Seal
- Replacing. Refer to RIGHT SEAL, REPLACING
- Seal
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING
- For the selector shaft
- Right Seal
- Replacing. Refer to RIGHT SEAL, REPLACING
- For vehicles with All Wheel Drive (AWD)
- Seal
- Always replace after removing
- Insert in the surrounding right flange shaft groove
- Remove to replace needle bearing (polygon bearing) -item 7-. Refer to RIGHT FLANGE SHAFT NEEDLE BEARING, REMOVING AND INSTALLING .
- Right Flange Shaft
- For vehicles with AWD
- Removing and installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING, VEHICLES WITH ALL WHEEL DRIVE .
- Needle Bearing (Polygon Bearing)
- Replacing. Refer to RIGHT FLANGE SHAFT NEEDLE BEARING, REMOVING AND INSTALLING .
- If the flange shaft is difficult to move when it is removed, this is not a fault
- Acoustical test only when installed
- Check for damage, for example for cracks on the out race
- Bevel Box
- Seal
- Replacing. Refer to OUTPUT FLANGE SEAL, REPLACING
- For output flange
- For vehicles with AWD
- Seal
- Replacing. Refer to SEAL ON BEVEL BOX BETWEEN TRANSMISSION AND BEVEL BOX, REMOVING AND INSTALLING
- Between the transmission and the bevel box, on the bevel box
- For vehicles with AWD
- Left Seal
- For the left flange shaft
- Replacing. Refer to LEFT SEAL, REPLACING