Replacing, Right Seal On Transmission Between Bevel Box And Transmission

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the bevel gear. Refer to BEVEL BOX, REMOVING .

-- Place the :SMN372500 under the transmission.

-- Pry out the sealing ring on transmission using the :T20143/1 or :T20143/2 .

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the parts information.

Courtesy of AUDI OF AMERICA, LLC

-- Install the seal all the way in using the :T10243 . Be careful not to tilt it.

Courtesy of AUDI OF AMERICA, LLC

-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .

-- Check transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .