Fill Gear Oil

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

All precautionary measures and test conditions must be followed.

-- If installed remove the bolts -arrows-, and remove the right drive axle heat shield.

-- Route the :VAS6291A upward.

Courtesy of AUDI OF AMERICA, LLC

-- Install the :VAS6291/3 until stop.

-- Attach the charging device hose with the :VAS6291/3 .

NOTE:

The hose must not hang through.

-- Check if the valve -arrow- is closed.

Courtesy of AUDI OF AMERICA, LLC

-- Install the oil container -A- on the :VAS6291A .

-- Open the valve -arrow- and hold the oil container as illustrated.

When gear oil flows out the :VAS6291/3 , the gear oil level is OK.

Courtesy of AUDI OF AMERICA, LLC

-- Hold the oil container in such a way so that any excess oil flows back into the container.

-- When the oil stops flowing, disconnect the charging device by pushing the tab.

-- Remove the :VAS6291/3 .

Assembling

Assembly is performed in the reverse order of disassembly, noting the following:

NOTE:

Replace the oil filler hole drain plug.