Right Seal, Replacing: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Transmission installed

NOTE:

Observe general notes. Refer to GENERAL INFORMATION .

Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING, VEHICLES WITH ALL WHEEL DRIVE .

-- Remove the right seal with the :T20143 .

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the parts information.

-- Install the seal all the way in using the :T10049 . Be careful not to tilt it.

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING, VEHICLES WITH ALL WHEEL DRIVE .

-- Check the gear oil level. Refer to GEAR OIL, CHECKING LEVEL .